Article Blog Wiki

In this article I would like to go into the re coating method for hard wood flooring surfaces. Re-coating is a cost effective way to revive worn out or dull hardwood floors. Nevertheless, it isn’t for all floors. Flooring surfaces that have deep scarring or scratches which have penetrated the top finish layer can’t be re-coated. In addition, flooring surfaces which have been cleaned with wax cleaners for example; oil soaps, orange glow etc also cannot be re-coated. Other floors that can’t be re-coated are flooring surfaces with aluminum oxide finishes. If you are thinking about re coating a pre finished floor or an engineered wood ground it is really a great concept to check the manufacturers suggestion for re coating.

Now that we have covered all of the flooring surfaces that can’t be re coated, we can talk about how to obtain started on those floors that could be.

Here is what you will require:

A flooring scrubber. These could be rented at your local home store or tool rental shop. If you’ve never used a floor buffer, it is really a great concept to use what is called a square scrubber. Square buffers vibrate instead of oscillate, so they’re much easier to operate.

First, you’ll wish to buff the entire ground with the ground buffer using the white pad and the sanding screen on it. This will remove some with the surface scratches as well as rough up the finish that’s already there. Roughing up the finish assist permit the new coatings to bond to the floor.

Following the floor has been thoroughly buffed with a floor buffer. You’ll want to vacuum the floor. Be sure to get each and every bit of dust or debris vacuumed up. Next, Take your micro fiber dust mop and dampen it with some mineral spirits. Then mop over the ground once or twice, being certain to shake out the mop after each time and re damped the mop before each time.

Following the ground is cleaned, allow the mineral spirits to dry for about 15 minutes. Next, take the sanding sealer and stir it up truly well. Then apply the sanding sealer with one with the water dependent floor applicators. This should take about 1-3 hours to dry.

After the sanding sealer has dried, you’re now ready to utilize the finish which you decide on. For the oil based use a lambs wool applicator. Or for the water based finish use the water dependent applicator. It is usually easiest to apply it thin to prevent streaks. If it was put on thin, you may want to re buff the floor, clean it again with a Pullman Holt floor buffer and utilize an additional coating of finish. It isn’t required to apply the sanding sealer once again.

Finally, wait for that floor to dry and wait the finish manufactures advised time for curing before moving furnishings back onto the floor.